The branches of Lycium barbarum hanging is very elegant. For the newly planted Lycium barbarum seedlings, the top shall be removed when the trunk is 60 cm high, and 3 to 5 lateral branches shall be selected. In the second year, the selected 3 to 5 lateral branches will be retracted to 30 cm to form the first layer of crown. The twigs are green, drought resistant and afraid of waterlogging. We usually do a good job in the daily maintenance of medlar bonsai, which can not only avoid its yellow leaves, but also make it lush and emerald
In the flowering and fruiting period, water appropriately to prevent over drying or over wetting. Thin fertilizer should be applied frequently, and the leaves should be picked in combination in early summer and early autumn. A slightly thick fertilizer can be applied once each to promote them to produce new leaves and flower buds. Make it have a certain inclination with the soil surface, so it will not hinder the growth of its roots. After planting, cover with 20 gallon plant pots soil and add a layer of sand. If the basin soil is wet, do not water it for a short time.
Micro irrigation and fertilization is the development direction of integrated water and fertilizer management. Driven by mechanical power or water level drop, it synchronously sends the water and nutrients required by crops to crop rhizosphere soil in the form of aqueous solution. The fruiting body will grow poorly, especially in the later stage, and there will be premature aging. Especially in the case of poor quality of culture material, less feces, more grass and thin material layer, it will significantly affect the yield and quality.
At present, the stored seeds are soaked in warm water at 40 �?? for 24 hours before sowing to improve the germination rate, which is generally about 90%. The sowing date is from late March to mid April. If there is no watering condition or the water source is insufficient, cover it with fine sand and soil slightly after sowing, cover it with plastic film, and fully cover it with soil for 1.5 ~ 2cm on the plastic film, so as to prevent it from entering the sun. Observe it every day, and remove the film in cloudy and rainy weather when the seed buds penetrate the soil.
If the potted fig tree is large, we can use bagging to keep it warm to ensure that it will not be frostbitten. When the temperature is low in winter, figs generally enter a dormant state. The root system of fig is relatively developed, which requires large container cultivation. Generally, it is planted in 1 gallon nursery pots, and needs a large space growth environment. The open balcony, terrace and courtyard are more suitable for its growth.
Kuju believes that many people prefer planting, because it is edible and the best food to clear away heat and fire, so it has a lot of room for development in the market. In the peak season of plant growth, it is also necessary to keep the soil moist. If the water is insufficient, the bitter taste of bitter chrysanthemum is heavy and the taste is poor. When it is harvested quickly in the later stage of growth, it is necessary to control the water and ensure the quality.
The rootstocks used for grafting Alpine vegetables are required to have the characteristics of high affinity, stress resistance, yield and quality. The selection of Rootstocks after grafting has an obvious effect of resisting soil borne diseases and improving quality. White fluorescent lamps of 100 ~ 300 watts can also be used, which can also meet certain lighting conditions and meet the growth requirements of plants; When the light source is close to the plant, it will not burn the plant.
If the room temperature is higher, you can pour more water. If you place it in a room with a room temperature of about 5 �??, you should control the water and keep the 25 gallon pots soil slightly dry as far as possible, so that you can spend the winter safely. In winter, some rotten cake fertilizer and vegetable cake organic fertilizer can be applied at an interval of about half a month. When the plant returns to normal growth, the concentration of liquid fertilizer can be increased appropriately.
The purpose of pruning branches is to promote the germination of axillary buds and the fruiting branches for winter. The fruits produced on the main branches and stems should be removed, so that more nutrients can be stored, and the retained fruits can grow larger and higher quality. The moisture content of soil is 60% ~ 70%, which can meet the water absorption of leaves, reduce transpiration, promote the cell division of cuttings, and finally the light intensity.
Erase the lateral buds. When raising Lingjian lotus, many flower friends often bloom only 1 ~ 2 flowers in the whole plant, mainly because there is no pruning. When pruning the fortune tree, it is also necessary to prune the branches with poor growth in time, so as to reduce the consumption of nutrients and promote the vigorous growth of healthy branches. It is mainly to erase the lateral buds on the upper part of the plant, and only need to keep the lateral buds in the basin soil and close to the soil surface.
Pinch off the new arrow(5 gallon nursery pots). When making the arrow, the lotus flower should not only ensure the light and nutrients, but also make the new arrow grow at one time. When the new arrow is 30cm high, the top of the new arrow can be pinched off to prevent the new arrow from growing again. From the pruning picture of the lotus arrow, it is not difficult to see that if the top of the new arrow is not pinched off, the second growing new arrow will be thick and thin, which is very unsightly.
Cutting off the old leaves in the growth process of Lingjian lotus, generally, the flower branches that have bloomed more than 2 times will age, begin to harden, appear lignified, and will not bloom next time. In order to ensure that Lingjian Lotus can bloom every year, cutting off the old branches is very necessary. Wait until winter, in addition to pruning the withered chrysanthemum branches, don't prune any more, so as to make the winter safe.
In fact, pinching off the axillary buds is also very important. When the chrysanthemum is in the strong seedling stage, it will grow a lot of small axillary buds. These small axillary buds will produce a lot of disordered lateral branches, which makes the plant feel very messy. It must be pinched off by hand in time. However, it should be noted that these small axillary buds should be pinched off with fingers, not scissors. You can cut off the old branches that have bloomed after the flowers wither, and keep the others.
Pruning flower buds when the chrysanthemum is pregnant, there are always many side buds on the twigs of the top bud of the flower branch(plastic planters). We need to timely remove the side buds on the twigs under the top bud with scissors to ensure that only one flower bud at the top is left on each flower branch of the chrysanthemum. Or leave a spare bud, but when the top bud has begun to have color, you can directly cut off the spare bud.
After flowering, the pruning steps of chrysanthemum before flowering are many, but even after flowering, the withered flower branches should be cut off from the root (or from 2 cm above the soil, which does not affect the plant). If the withered flower branches are left behind, they will be bare and very ugly. In addition, those seedlings born at the root do not need to be cut and can survive the winter safely.
The weather is hot in summer, and dehydration is easy to occur after pruning, so pruning shall be minimized. When autumn comes, it is necessary to sun new flower buds and pinch off axillary buds. Autumn is the best time to prune chrysanthemum potted plants. However, if its branches and leaves grow in vain, they need to be cut off in time to save nutrients and promote the growth of other branches and leaves. These cut branches and leaves can be cut separately and cultivated into new plants.
During the budding period of chrysanthemum, in addition to the flower buds with the size of soybean grain on the top, small side buds may also grow next to it. In order to make the chrysanthemum blossom bigger and more beautiful, we usually need to cut off the redundant side buds with tweezers in the morning(15 gallon plant pot). When thinning buds, pay attention to leaving a spare bud to prevent the top bud from not flowering. After the top bud blooms, the left side buds can be cut off.
Flowering and pruning during chrysanthemum flowering, we need to cut off the flowering branches in time. When cutting off the branches, we need to pay attention to pruning from the root. When the flowering period of the whole chrysanthemum is over and no longer blooms, we need to cut off the withered and old parts of the stems in the pot, so as to maintain the beauty of the pot. After pruning and flowering, chrysanthemums need to be prepared for winter, and then wait for the next year.
When we cut off the withered and old branches, we need to pay attention to leaving the perennial roots. The seedlings growing next year will survive better and have strong vitality. 2ã?? Three precautions for chrysanthemum pruning 1. Clean disinfection when pruning chrysanthemums, we need to pay attention to keeping the environment clean and hygienic. After pruning branches, we should avoid chrysanthemum bacterial infection due to environmental pollution, resulting in Chrysanthemum diseases.
At the same time, our pruning tools also need to be boiled with boiling water before disinfection, and then dried for pruning(plastic flower pots wholesale). During pruning, pay attention to make the incision as smooth as possible. 2. When pruning the branches of chrysanthemum, we mainly prune the branches higher than the chrysanthemum, and try not to prune the too low branches. If the low branches close to the root are pruned at will, the plant may grow slowly.
|